Kyocera FS-1030MPF Service Manual page 107

Code
6000 Broken Fuser heater wire
The fuser temperature does not rise
after the Fuser heater has been
turned on.
6020 Abnormally high fuser thermistor
temperature
Fuser thermistor detects abnormally
temperature.
6030 Broken fuser thermistor wire
Input from fuser thermistor is 0 (A/D
value).
Contents
Causes
Poor contact in Reinsert the connector (See page 1-5-
the fuser therm- 32).
istor connector
terminals.
Poor contact in Reinsert the connector (See page 1-5-
the Fuser heater 32).
connector termi-
nals.
Fuser thermistor Replace the fuser unit (See page 1-5-
installed incor- 32).
rectly.
Fuser thermal Replace the fuser unit (See page 1-5-
cutout triggered. 32).
Fuser heater Replace the fuser unit (See page 1-5-
installed incor- 32).
rectly.
Broken Fuser Replace the fuser unit (See page 1-5-
heater wire. 32).
Shorted fuser Replace the fuser unit (See page 1-5-
thermistor. 32).
Defective control Replace the control PWB (See page 1-
PWB. 5-37).
Poor contact in Reinsert the connector (See page 1-5-
the fuser therm- 32).
istor connector
terminals.
Broken fuser Replace the fuser unit (See page 1-5-
thermistor wire. 32).
Fuser thermistor Replace the fuser unit (See page 1-5-
installed incor- 32).
rectly.
Fuser thermal Replace the fuser unit (See page 1-5-
cutout triggered. 32).
Fuser heater Replace the fuser unit (See page 1-5-
installed incor- 32).
rectly.
Broken Fuser Replace the fuser unit (See page 1-5-
heater wire. 32).
1-4-10
2MH/2MJ/2MK/2ML
Remarks
Check procedures
/corrective measures