3) Speaker, buttons, etc. (See Fig. 3.)
As shown in Fig. 3, remove the nuts, speaker button
OP, and LED lens. Undo the hooks and remove
front buttons.
S-25
Speaker Ass'y
Front Foot
Fig. 3
4) Insulation barrier, urethane foam shield, etc. (See
Fig. 4.)
As shown in Fig. 4, the front cabinet is lined with
the barrier sheet.
Fig. 4
S-25
LED
Lens
Button
OP
Top Cover
Top Cover
11
5) Disassembling the front panel (See Fig. 5.)
Remove the screw (S-12) shown in Fig. 5, and
detach the front door.
Remove the screw (S-4) and take out the IR PWB.
Remove the two screws (S-1) and detach the plates.
Remove the screw (S-4) each off the right and left
front hooks, and detach the hooks.
S-4
S-18
Front Door
Fig. 5
6) F/E PWB (See Fig. 6.)
Remove the screw (S-13) and two screws (S-5)
shown in Fig. 6, and disconnect the connectors.
Remove the screw (S-13) and two RGB spacers,
and detach the connector panel.
S-5
S-13
S-23
S-23
Fig. 6
PG-M10SU/SE
PG-M10XU/XE
S-12
S-1
S-4
S-4
S-13
RGB Spacer
Connector
Panel
S-5
S-23
F/E PWB