Sony VPH-G70Q Operating Instructions Manual page 14

Location and Function of Controls
Battery installation
1
Push to open the lid.
2
Install the three R6 (size AA) batteries (supplied)
with the correct polarity.
Be sure to install
the battery from
the ' side.
3
Replace the lid.
Notes on batteries
• Be careful that the battery orientation is correct when
inserting batteries.
• Do not mix old battery with new one, or different
types of batteries.
• If you do not intend to use the remote control for a
long time, remove the batteries to avoid damage from
battery leakage. If a battery has leaked, remove the
batteries, wipe the battery compartment dry and
replace the batteries with new ones.
14
(EN)
Notes on wireless remote control operation
• Be sure that there is nothing to obstruct the infrared
beam between the remote control and the projector.
• The operation range is limited. The shorter the
distance between the remote control and the
projector, the wider the angle within which the
remote control can control the projector.
• The remote control detectors on the projector do not
operate when the remote control is being used as a
wired remote control. If you wish to use the remote
control as a wireless remote control, be sure to
remove the connecting cable from both the remote
control and the projector.
Connecting the remote control to the
projector
Rear of the projector
CONTROL S
Remote control cable (supplied)
IN
PLUG IN
POWER
CONTROL S IN
OUT
CONTROL
S OUT