Image Backup And Recovery Procedures - Fujitsu Stylistic V535 Operating Manual

Problem
Unavailable network connection
(continued)

Image Backup and Recovery Procedures

This procedure only applies to the Windows 8.1 system and is NOT applicable to the Windows
Embedded 8.1 system. (Check Control Panel - System - Windows Version to see which system you have).
Thank you for purchasing a Fujitsu computer. Fujitsu is committed to bringing you
the best computing experience with your new system.
It is very important that you create DVD copies of your Recovery Image and Bootable Disk
before beginning to use your system. To do so, follow the instructions in the "Creating a
Backup of Bootable Disk and Recovery Image" section of this document.
Fujitsu
Possible Cause
The WLAN device was
deactivated or is disabled
The computer to be connected
is turned off
Incorrectly configured network
settings
RF interference from Access
Points or other wireless
networks
Wireless network authentication
has failed
Incorrect IP address
configuration
Possible Solution
Check if the wireless switch
is turned On. Go to Start >
Control Panel, and doubleclick
on Windows Mobility Center. If
the wireless network is off, click
the Turn wireless on button.
Check if the computer to be
connected is turned ON.
Recheck the configuration of
your network settings.
The use of identical or
overlapping RF channels can
cause interference with the
operation of the WLAN device.
Change the channel of your
Access Point to a channel
that does not overlap with the
interfering device.
Re-check your Network
Authentication, Encryption,
and Security settings.
Incorrectly configured
security settings such as
an incorrectly typed WEP
key, a mis-configured LEAP
username, or an incorrectly
chosen authentication method
will cause the LAN device to
associate but not authenticate
to the wireless network.
This only applies to networks
using static IP addresses.
Please contact your network
administrator for the correct
settings.
Appendix
93