Error Messages On The Screen - Fujitsu Stylistic V535 Operating Manual

Error messages on the screen

Errors Error messages onthescreen
This section describes the error messages generated by the BIOS Setup. Error messages displayed
by the operating system or programs are described in the documentation for these programs.
If the error message appears repeatedly despite troubleshooting measures,
contact the place of purchase or our customer service center.
Error message/cause
System CMOS checksum bad - Default configuration
used
The system configuration information is
incorrect.
nn Stuck key
Operating system not found
Press <F1> to resume, <F2> to SETUP
This error message appears if an error occurs
during the self-test before starting the operating
system.
Real time clock error
nnnnK Shadow RAM failed at offset: xxxx Failing
Bits: zzzz
System battery is dead - Replace and run SETUP
System cache error - Cache disabled
System timer error
Fujitsu
Troubleshooting
► Switch the Tablet PC off.
► Switch the Tablet PC on.
► Keep the volume button and the shortcut
button pressed and switch the Tablet PC
on. If you keep the volume button pressed
during the boot process, you can switch into
the BIOS Setup-
► In the BIOS Setup, select the Exit menu.
► Select the entry Load Setup Defaults.
► Select OK and press the Enter key.
► Make sure that no key is pressed.
► Check in the BIOS Setup whether your hard
disk has been set correctly.
► Make sure that the operating system is
installed on the corresponding drive.
► Press the tablet button to boot the
Alt
operating system
► Contact your sales outlet or our customer
service center.
► Contact your sales outlet or our customer
service center.
► Contact your sales outlet or our customer
service center.
► Contact your sales outlet or our customer
service center.
► Contact your sales outlet or our customer
service center.
Troubleshooting and tips
75