Displaying From A Mac Laptop; Solutions When "Not Supported" Message Appears; Solutions When Only A Partial Image Appears - Epson PowerLite 4770W User Manual

4. If necessary, check your video card settings and set the multiple display option to Mirror or
Duplicate.
Parent topic:

Displaying From a Mac Laptop

If you see the "No Signal" message when you display from a Mac laptop, you need to set up the laptop
for mirrored display. (See your laptop manual for details.)
1. Open the System Preferences utility and select Displays.
2. Click the Arrangement tab.
3. Select the Mirror Displays checkbox.
Parent topic:

Solutions When "Not Supported" Message Appears

If the "Not Supported" message appears, try the following solutions:
• Make sure the correct input signal is selected on the Signal menu.
• Make sure the computer's display resolution does not exceed the projector's resolution and frequency
limit. If necessary, select a different display resolution for your computer. (See your computer manual
for details.)
• As a test, try setting the computer's display resolution to the lowest possible setting, and then
gradually increase it as necessary.
Parent topic:
Related references
Input Signal Settings - Signal Menu

Solutions When Only a Partial Image Appears

If only a partial computer image appears, try the following solutions:
• Press the Auto button on the remote control to optimize the image signal.
• Make sure you selected the correct Screen Type setting for the screen being used.
• Try adjusting the image position using the Screen Position menu setting.
• Press the Aspect button on the remote control to select a different image aspect ratio.
• If you zoomed into or out of the image using the E-Zoom buttons, press the Esc button until the
projector returns to a full display.
Solutions When "No Signal" Message Appears
Solutions When "No Signal" Message Appears
Solving Image or Sound Problems
171