IBM eserver xSeries 360 8686 User Reference Manual page 86

Hide thumbs Also See for eserver xSeries 360 8686:
Table of Contents

Advertisement

4. Slide the expansion-slot cover up out of the server and move the blue PCI-
5. Remove the ServeRAID adapter from the static-protective package and install the
6. Move the blue PCI-adapter locking lever to the left (as viewed from the front) to
7. For internal hard disk drive connections:
8. Refer to the documentation provided with the ServeRAID adapter for information
9. If you have other options to install or remove, do so now; otherwise, go to
72
IBM® xSeries 360: User's Reference
adapter locking lever (near the rear of the Remote Supervisor Adapter) to the right
(as viewed from the front) to permit inserting the ServeRAID adapter.
Attention: When you handle Electrostatic Discharge-Sensitive devices (ESD),
take precautions to avoid damage from static electricity. For details on handling
these devices, see "Handling static-sensitive devices" on page 52.
adapter, pressing it firmly into the selected PCI-X slot.
secure the adapter; then, lower the adapter-retention latch over the top corner of
the adapter. The orange adapter-retention tab snaps into place.
a. Plug in one end of the ServeRAID internal channel cable (shipped with the
server) to an internal ServeRAID channel connector on the top edge of the
ServeRAID adapter as shown in the following illustration. You can install the
adapter in any PCI-X slot. It is shown in slot 6 here only as an example.
b. Route the cable along the surface of the system board toward the front of the
server, then to the right under the adapters and dividers, and plug it into the
SCSI RAID cable connector (J43) on the system board.
Notes:
1) You cannot install a full-length, wide adapter in PCI-X slot 1 if the SCSI
RAID adapter cable connector is in use.
2) You might need to remove adapters or plastic dividers to access the
ServeRAID connector on the system board.
SCSI RAID
cable connector
about installing the ServeRAID software and configuring the ServeRAID adapter.
"Completing the installation" on page 86.
ServeRAID adapter

Advertisement

Table of Contents
loading

Table of Contents