Sanyo VCC-HD5400P Service Manual page 12

2-5. Adjustment
1. Timer Quartz Adjustment
Adjustment location: CT351 (CA-5)
Measuring location: CL351 (CA-5)
Measuring equipment: Frequency counter
Subject: No designation
Preparation:
Turn on the switch and wait for 1 minute.
Temperature: 25 ± 5°C
Adjusting method:
1. It turns on power .
2. Adjust with CT351 to 32769.901 Hz - 32770.032 Hz.
CT351
CP-2 BOARD SIDE A
2. Lens Adjustment (Infinity)
Camera
TP351
Collimator
Adjustment location: QrCode of computer screen, Infinity
Measuring location: Computer screen
Measuring equipment: Collimator
Preparation:
If using a ready-made collimator, set to infinity.
Note:
Do not vibrate during the adjustment.
If readjusting after it has already been adjusted, wait for 15
minutes or more for the unit to cool down first.
Adjusting method:
1. It turns on power.
2. Set the camera so that it becomes center of the screen in
the collimator.(Tele and Wide)
3. Connect the camera's USB terminal to the computer'
USB connector.
4. Double-click on the DscCalDi.exe.
5. Click the "QrCode".
6. QrCode Input Dialog display will be displayed.
QrCode Input Dialog
Bar code Input
Save Load
Status:
7. Deselect Bar code Input.
8. Enter the alphanumeric characters which are underneath
the bar code which is included with the lens.
B086 A079 B374 B086 A079
QrCode Input Dialog
B086
A079
Bar code Input
Save Load
Status:
9. Click the Execute.
10. Click the OK.
11. Select "Infinity Cal." on the LCD "Test", and click the "Yes".
12. Lens infinity adjustment value will appear on the screen.
13. Click the OK.
Note:Bar code and QrCode
Bar code
QrCode
K A 0 7 2 2 2 0 0 0 1 A B 0 8 6 A 0 7 9 B 3 7 4 B 0 8 6 A 0 7 9 0 0
Read character
Digit number 1-12
3. Lens Adjustment (1m) is carried out after this adjust-
ment.
- -
12
Cal. of computer screen
Get
Execute OK
NO. 1032A
B374
B086 A079
Get
Execute OK
NO. 1032A
B086 A079 B374 B086 A079
13-16 17-20 21- 24 25-28 29-32 33-34