Table of Contents
Advertisement
6.
Apply thermal grease on top of the CPU.
7.
Put the CPU Fan down
on the retention module
and snap the four reten-
tion legs of the cooling
fan into place.
8.
Flip the levers over to lock the heat sink in place.
9.
Connect the CPU Cool-
ing Fan power cable to
the CPUFAN1 connec-
tor. This completes the
installation.
•
To achieve better airflow rates and heat dissipation, we suggest that
Notes:
you use a high quality fan with 4800 rpm at least.
•
CPU fan and heatsink installation procedures may vary with the type of
CPU fan/heatsink supplied. The form and size of fan/heatsink may also
vary.
I
n
s
t
a
l
l
i
n
g
M
e
m
o
I
n
s
t
a
l
l
i
n
g
M
e
m
o
This mainboard accommodates two 184-pin 2.5V unbuffered Double Data
Rate SDRAM (DDR SDRAM) Dual Inline Memory Module (DIMM) sockets,
and supports up to 2.0 GB of 200/266 MHz DDR SDRAM.
DDR SDRAM is a type of SDRAM that supports data transfers on both edges
of each clock cycle (the rising and falling edges), effectively doubling the
memory chip's data throughput. DDR DIMMs can synchronously work with
100 MHz or 133 MHz memory bus.
DDR SDRAM provides 1.6 GB/s or 2.1 GB/s data transfer rate depending on
whether the bus is 100 MHz or 133 MHz. DDR SDRAM uses additional power
and ground lines and requires 184-pin 2.5V unbuffered DIMM module.
Do not remove any memory module from its antistatic packaging until
you are ready to install it on the mainboard. Handle the modules only by
their edges. Do not touch the components or metal parts. Always wear
a grounding strap when you handle the modules.
r
y
M
o
d
u
l
e
s
r
y
M
o
d
u
l
e
s
9
Hide quick links:
Advertisement
Table of Contents
