N40475
Figure 14
Figure 15
Figure 16
Cables required
Where Used: Connects the PCP and MMPD displays
into the J1939 data link.
The J1939 data link (item 1 figure 14) can not exceed
40 meters (131 ft.).
Requires:
MMPD drop cable
Tee to Tee cable
6-pin Tee
Termination resistor
Termination resistor (figure 15)
Used to terminate the ends of a data link run. Two
termination resistors required
Tee connector (figure 16)
Used to connect tee to tee cables.
CAN Data Link
SAE J1939-15: Unshielded twisted pair.
The CAN network operates at 250 Kb/sec, it follows
J1939-15 protocol.
Maximum Drops (nodes)
Maximum Cable Stub Length
Maximum Cable Stub Length for
service connector
Maximum Bus Length
Shielded Cable
Chapter 8
J1939-15
10
3M
2.66M
40M
NO
Page 35