Ranger RCI-2985DX User Manual page 8

DX
RCI-2985
DX
RCI-2995
23. LOCK BUTTON (LOCK)
This button is used to lock a selected frequency. Press it to activate the switch. In this position, it
disables the Frequency Selector Control, up/down buttons on the front control panel and remote
up/down buttons on the microphone. Repressing the switch will unlock the frequency.
24. ENTER BUTTON (ENT)
This is used to program memory channels. See the OPERATION section of this manual for more
information on using this control.
25. MEMORY BUTTON (MEM)
This button is used to program memory channels. Detailed information on how to use this control is provided in the OPERATION section of this manual.
26. SCAN BUTTON (SCAN)
This is used to scan frequencies in each band segment. The OPERATION segment of this manual
provides detailed information on using the SCAN control.
27. SWR BUTTON (SWR)
This button is used to check SWR.
28. DIM BUTTON (DIM)
This button adjusts the display backlighting in four different steps to best match the ambient light.
3.1.3 REAR PANEL
Figure 3-2 represents the location of the following connections:
1. ANTENNA
This jack accepts 50 ohms coaxial cable with a PL-259 type connector.
Figure 3-2 Rear Panel
- 8 -
CHAPTER 3
INTRODUCTION