Moen FOUR-INCH CENTERSET 4200 Installation Instructions

4200, 4220, 4330, 4340, 4350,
4400, 4641, 4643 SERIES
LEVER HANDLE
1-3/4"
3-5/8" C.C.
CONCENTRIX HANDLE
1-3/4"
3-5/8" C.C.
CAUTION:
Before turning water on during either rough-in or trim-out, make sure that the cartridge retainer clip is in place. The cartridge and
retainer clip were properly installed and tested before leaving the factory. Although it is unlikely, it is nevertheless possible that
through the handling of the valve by any number of persons the retainer clip may not be properly installed. This should be carefully
checked at time of rough-in and trim-out. If the retainer clip is not properly installed, water pressure could force the cartridge out
of the casting. Personal injury or water damage to the premises could result.
®
LAVATORY FAUCETS
Four-Inch Centerset
5" NOMINAL
OPEN
POSITION
1-3/4"
MAX.
1/2" IPS
THREADED
CONNECTIONS
HANDLE INSERT
(NOT
INCLUDED)
5" NOMINAL
OPEN
POSITION
Fits 4" centers and through a 1" minimum diameter hole.
All models equipped with a Moen Flow-Rator™.
Complies with ASME A112.18.1M and CSA B125
Always turn water off before disassembling the valve. Open valve handle to alleviate water
pressure to insure that complete water shut-off has been accomplished.

INSTALLATION INSTRUCTIONS

THESE INSTRUCTIONS MUST BE
1-3/4"
6" X 2" WIDE
4-3/4"
LIFT ROD
POSITION
With clamp bar, spacer and
mounting nut installed, tilt
clamp bar back as shown,
then drop faucet supplies
down through deck holes and
tighten from below. On decks
thicker than 3/4" you may
have to remove spacer.
LEFT WITH HOMEOWNER
KNOB HANDLE
5" NOMINAL
POSITION
3-5/8" C.C.
USE SPACER TO INSTALL
ON THINNER LAVATORY
BOWLS OR COUNTERS
DISCARD SPACER WHEN
INSTALLING ON THICKER
LAVATORY BOWLS OR COUNTERS
TILT BACK
CLAMP BAR
MT123A
OPEN
Clip
Ear