Periodical Execution; Trouble Sending; Event Triggered Execution - Sony SNC-WR630 User Manual

is necessary when the SMTP server that sends e-mails
performs authentication.
Address
Recipient e-mail address 1, 2, 3
Type the recipient e-mail address using up to 64
characters.
You can specify up to three recipient e-mail addresses.
Administrator e-mail address
Type the Administrator e-mail address using up to 64
characters.
This address is used for reply e-mails and sending
system messages from the mail server.
Content
Subject
Type the subject/title of the e-mail.
The length for entering letters should be within
60 characters.
An e-mail sent in response to alarm detection will
indicate the type of alarm in the subject. (Sensor1) is
added for sensor input 1 detection, (Sensor2) for sensor
input 2 detection, (Sensor3) for sensor input 3 detection,
(Sensor4) for sensor input 4 detection, (Tampering) for
camera interference detection, (VMD) for motion
detection, (VMF) for VMF detection, (Disconnected)
for network disconnection detection, (Face Detection)
for face detection. (Event1 (Condition1)) is additionally
available for event condition detection.
Message
Type the text of the e-mail.
The length for entering letters should be within 384
characters.

Event triggered execution

File attachment
Set whether an image file (JPEG file) is to be attached to
the e-mail or not.
When the checkbox is selected, the image file made
using the settings below is attached. When the checkbox
is deselected, only the message is sent.
Image file name
Type the file name you want to assign to the image to be
attached to an e-mail. You can use up to 10
alphanumeric characters, – (hyphen) and _ (underscore)
for naming.
The actual image file name will be the specified image
file name with a suffix and the extension .jpg.
52
Setting the Action output — Action output Menu
Suffix
Select a suffix to be added to the file name used when the
e-mail is sent.
None: The name of the sent file will be the image file
name.
Date & time: The date & time suffix is added to the
image file name.
The date & time suffix consists of last two-digits of
the year (2 digits), month (2 digits), date (2 digits),
hour (2 digits), minute (2 digits), second (2 digits),
and sequential number (2 digits), thus adding 14-
digit number to the image file name.

Periodical execution

You can set to send e-mails periodically.
Image file name
Type the file name of the image attached to the e-mail
using up to 10 alphanumeric characters, – (hyphen) and
_ (under score).
The actual image file name will be the specified image
file name with a suffix and the extension .jpg.
Suffix
Select a suffix to be added to the file name used when the
e-mail is sent.
None: The name of the sent file will be the image file
name.
Date & time: The date & time suffix is added to the
image file name.
The date & time suffix consists of last two-digits the
year (2 digits), month (2 digits), date (2 digits), hour
(2 digits), minutes (2 digits) and seconds (2 digits),
and sequential number (2 digits), thus adding a 14-
digit number to the image file name.

Trouble sending

Set to send the e-mail when the problem is detected.
Enable
Select the checkbox to enable the sending of problem
reports.
Continuous sending
Set whether to enable continuous e-mail sending.
When the checkbox is selected, an e-mail will be sent
once an hour.
Recipient e-mail address
Type the recipient's e-mail address within 64 characters.
OK/Cancel
See "Buttons common to every menu" on page 20.