Precor C966i Service Manual page 8

13. Press the BACK key to exit the U-Boot SW display.
14. U-BASE SW display. This display the installed version of upper PCA software.
15. Press the OK key. The software part number will be displayed as XXXXX-XXX.
16. Press the BACK key to exit the U-Base SW display.
17. LOWER SW display. This display the installed version of lower PCA software.
18. Press the OK key. The software part number will be displayed as XXXXX-XXX.
19. Press the BACK key to exit the lower SW display.
20. SER. NUMBER display. Press the OK key.
21. The treadmill's serial number will be displayed. The serial number may be incorrect or not
displayed if the upper PCA has been replaced.
22. Press the BACK key to exit the serial number display.
23. USAGE LOG display. Press the OK key.
24. Use the , keys to move through the list of programs. A message will scroll describing the
program, the number of times and the number of minutes the program was used.
25. Press the BACK key to exit the usage log display.
26. ERROR LOG display. Press the OK key, the quantity of errors in the log will be displayed.
27. Press the OK key, the most recent error will be displayed first.
28. Use the , keys to move through the list of errors. The error messages will list the error
name, the odometer reading when the error occurred, the hour meter when the error
occurred and the drive motor current reading when the error occurred.
29. If you wish to clear the error log, press and hold the QUICK START key. The message
HOLD TO CLEAR ERRORS will be displayed. The error log will be cleared when the
message NO ERRORS is displayed.
30. Press the RESET key to exit the information display.
31. Please note that the ERROR LOG may also be accessed at any time by pressing and
holding the RESET key for four seconds. If the error log does not contain any errors, the
message STUCK KEY will be displayed.
Page 1-8
C956i, C966i (Gen 06) Treadmill
Page 8