Main Guidelines - PROEL PLLEDMLW User Manual

MAIN GUIDELINES

Warning! This product is not for household use.
-
Read this manual before powering or installing the fixture, follow the safety precautions listed below
-
and observe all warnings in this manual and printed on the fixture. If you have questions about how
to operate the fixture safely, please contact a PROEL distributor for assistance. Refer any service
operation not described in this manual to a qualified technician.
Do not modify the fixture or install other than genuine PROEL accessories and upgrade kits.
-
Refer servicing to qualified personnel.
-
Maximum ambient temperature T
-
Suitable for mounting on normally flammable surfaces.
-
Do not look directly into the light.
-
Risk of fire, electrical shock and burns.
-
Use only in dry locations.
-
For indoors use only.
-
Do NOT block exhaust vents.
-
If the external power cord of this luminaire is damaged, it shall be replaced by a special cord
-
exclusively available from your PROEL dealer.
Warning always disconnect from mains power before replacing fuses, or any part, and when not in
-
use.
Before operation ensure that factory setting of voltage and frequency match local power supply.
-
Always ground (earth) the fixture electrically.
-
Use only a source of AC power that complies with local building and electrical codes and has both
-
overload and ground-fault protection.
Do not expose the fixture to rain or moisture.
-
Never operate the fixture with missing or damaged lenses and/or covers.
-
Warning the exterior of the fixture can become hot. Allow to cool for at least 20 minutes before
-
handling or opening.
Minimum distance to flammable material = 1 m.
-
Never attempt to bypass fuses. Always replace defective fuses with ones of the specified type and
-
rating.
Ensure that the air flow through vents is free and unobstructed.
-
Provide a minimum clearance of 0.1 meters around air vents.
-
Never place filters or other materials over the lens or in the optical path.
-
The exterior of the fixture can become hot. Allow the fixture to cool for at least 20 minutes before
-
handling.
Do not operate the fixture if the ambient temperature (T
-
Do not stare directly into the light.
-
= 40°C.
a
9
) exceeds 40° C.
a