Operation - DeWalt D25980 Instruction Manual

2. Hold the chisel in front of the tool holder with the groove (M) facing
upwards.
3. Insert the chisel shank into the tool holder (D).
4. Push the retainer (C) backwards to lock the accessory in position.
FIG. 4
C
D
M
TO FIT A CHISEL WITH COLLAR ON THE SHANK, PROCEED
AS FOLLOWS (FIG. 5):
1. Pull the tool retainer (C) to the unlock position.
2. Insert the chisel shank into the tool holder (D).
3. Push the retainer (C) in line with the accessory shank to lock the
accessory in position.
4. Pull on the chisel to check if it is properly locked. The hammering
function requires the chisel to be able to move axially several
centimetres when locked in the tool holder.
To remove a chisel pull back the retainer (C) and pull the chisel out
of the tool holder.
C

OPERATION

regulations.
Excessive force does not speed up chiselling but decreases tool
performance and may shorten tool life.
Proper Hand Position (fig. 1, 6)
use proper hand position as shown.
hold securely in anticipation of a sudden reaction.
Proper hand position requires one hand on each side handle (B).
26
FIG. 5
D
C
WARNING: Always observe the safety instructions and applicable
WARNING: Be aware of the location of pipework and wiring.
WARNING: Apply a pressure of approx. 20 – 30 kg to the tool.
WARNING: To reduce the risk of serious personal injury, ALWAYS
WARNING: To reduce the risk of serious personal injury, ALWAYS
C