Craftsman 315.108400 Owner's Manual page 15

TO BEVEL CUT
The angle of cut of your saw may be adjusted to any
desired setting between zero and 51.5°.
When making 45° bevel cuts, there is a notch in the
saw base to help you line up the blade with the line of
See Figure 19.
cut.
GUIDELINE
ALIGN INNER BLADE GUIDE NOTCH ON SAW BASE WITH
LINE OF CUT AS SHOWN WHEN MAKING 45
Align your line of cut with the inner blade guide notch
on the saw base when making 45° bevel cuts.
Since blade thicknesses vary and different angles
require different settings, always make a trial cut
in scrap material along a guideline to determine
how much you should offset the guideline on the
board to be cut.
OPERATION
BEVEL
SCALE
BLADE
GUIDE NOTCH
BEVEL ADJUSTMENT
WING NUT
°
BEVEL CUTS
Fig. 19
When making a bevel cut hold your saw firmly with
both hands as shown in Figure 20.
Rest the front edge of the base on the workpiece.
Squeeze the switch trigger to start your saw. Always
let the blade reach full speed, then guide your saw
into the workpiece.
LOWER
BLADE GUARD
WARNING:
The blade coming in contact with
the workpiece before it reaches full speed could
cause saw to "kickback" toward you resulting in
serious injury.
After you complete your cut release the trigger and
allow the blade to come to a complete stop. After the
blade has stopped, lift your saw from the workpiece.
TO ADJUST BEVEL SETTING
Unplug your saw.
WARNING:
Failure to unplug your saw could
result in accidental starting causing possible
serious personal injury.
See Figure 19.
Loosen wing nut.
Raise motor housing end of saw until you reach
desired angle setting on bevel scale.
See Figure 19.
Tighten wing nut securely.
WARNING:
Attempting bevel cut without wing
nut securely tightened can result in serious
injury.
15
Fig. 20