Configuring The Auto Light Setting; Hand Alignment Adjustment; Specifying The Illumination Duration - Casio 5470 Operation Manual

Auto Light
If Auto Light is enabled, display illumination
will turn on automatically whenever the watch
is positioned at an angle of 40 degrees or more
when it is dark.
Important!
Auto Light may not operate properly
●
when the watch is at a horizontal
angle of 15 degrees or greater from
horizontal as shown in the illustration
below.
Auto Light may operate
●
unintentionally and run down the
battery if the watch is blocked from
light by your sleeve.
Electro-static charge or magnetism
●
can interfere with proper auto light
operation. If this happens, try
lowering your arm and then angle it
towards your face again.
When moving the watch you may
●
note a slight rattling sound. This is
due to operation of the auto light
switch, which determines the current
orientation of the watch. It does not
indicate malfunction.
Note
Auto Light is disabled when any one
●
of the conditions below exists.
Alarm, timer alert, or other beeper
ー
sounding
Watch in the Compass Mode
ー
Time signal receive operation in
ー
progress
Hand movement operation is
ー
progress
If Auto Light is enabled, face
●
illumination may be delayed if you
angle the watch towards your face
while a compass, altitude,
barometric pressure, or temperature
reading operation is being
performed.
Operation Guide 5470
Configuring the Auto Light
Setting
1.
In the Timekeeping Mode, pull out the
crown.
40
degrees
or more
2.
Press (B) three times so [AUTO] is
displayed.
3.
Rotate the crown to turn the setting on or
off.
[ON]: Auto Light enabled.
[OFF]: Auto Light disabled.
4.
Push the crown back in to complete the
setting operation.
Specifying the Illumination
Duration
You can select either 1.5 seconds or three
seconds as the illumination duration.
1.
In the Timekeeping Mode, pull out the
crown.
2.
Press (B) four times so the current setting
([LIGHT1] or [LIGHT3]) is displayed.
3.
Rotate the crown to select an illumination
duration.
[LIGHT1]: 1.5-second illumination
[LIGHT3]: 3-second illumination
Crown
4.
Push the crown back in to complete the
setting operation.
Hand Alignment
Strong magnetism or impact can cause the
time indicated by the analog hands to become
different from the time on the digital display. If
this happens, correct the hand position.
The watch has a function to adjust hand
●
alignment automatically.
Important!
You do not need to perform the
●
operation below as long as the
analog hands indicate the same time
as the digital display.
Getting ready
Enter the Timekeeping Mode.
Navigating Between Modes
l
Crown
Adjustment
Timekeeping Mode
21