Table of Contents
Advertisement
TRACTOR - - MODEL NUMBER 917.273590
GROUND DRIVE
57
89
69
197
81
84
161
198
21
85
112
169
10
14
13
14
163
112
18
113
80
4
8
3
51
85
11
6
16
79
52 30
32
30
170
32
52
6
77
25
26
26
2
15
77
74
96
1
26
75
120
63
212
59
66
159
158
61
65
162
56
64
83
41
168
50
82
165
166
38
156
5
18
27
39
49
47
6
62
120
37
35
36
34
28
24
36
19
35
29
78
26
76
22
27
drive-fender.stlt_39
36
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY
SER VICE OR AD JUST MENTS:
1. Depress clutch/brake pedal fully and set parking brake.
2. Place gearshift lever in neutral (N) position.
3. Place attachment clutch in "DISENGAGED" position.
4. Turn ignition key to "STOP" and remove key.
5. Make sure the blades and all moving parts have completely stopped.
6. Disconnect spark plug wire from spark plug and place wire where it cannot
come in contact with plug.
TRACTOR
TO REMOVE MOWER
Mower will be easier to remove from the
right side of tractor.
1. Place attachment clutch in "DIS EN-
70
116
GAGED" position.
2. Move attachment lift lever forward to
low er mower to its lowest po si tion.
3. Roll belt off engine pulley.
55
4. Remove small retainer spring, and
remove clutch spring off pulley bolt.
5. Remove large retainer spring, slide
202
col lar off and push housing guide out
150
of brack et.
6. Disconnect anti-sway bar from chas sis
48
bracket by re mov ing re tain er spring.
7. Disconnect suspension arms from rear
151
deck brackets by removing retainer
51
springs.
8. Disconnect front links from deck by
re mov ing retainer springs.
9. Raise lift lever to raise suspension
arms. Slide mower out from under trac-
tor.
53
Clutch
Spring
Retainer
Spring
Anti-Sway
Bar
Collar
Housing
Guide
SERVICE AND ADJUSTMENTS
IMPORTANT: If an attachment other than
the mower deck is to be mounted on the
trac tor, remove the front links and hook
the clutch spring Into square hole in frame.
TO INSTALL MOWER
1. Raise attachment lift lever to its high est
position.
2. Slide mower under tractor with defl ec-
tor shield to right side of tractor.
3. Lower lift lever to its lowest po si tion.
4. Connect front links to mower deck and
secure with retainer springs.
5. Connect suspension arms to rear
deck brackets and secure with retainer
springs.
6. Connect anti-sway bar to chassis
bracket and secure with retainer spring.
7. Push clutch cable housing guide into
bracket, slide collar onto guide and
secure with large retainer spring.
Small Retainer Spring
Clutch Spring
Flat
Washer
Small Retainer
Suspension
Spring
Arms
Large Re tain er
Spring
Bracket
21
Square Hole
Engine
Pulley
Front Link
Retainer Springs
(Both Sides)
Defl ector
Shield
Advertisement
Table of Contents
