UTICA BOILERS 95M-200 Control Manual And Troubleshooting Manual page 21

display shows Para until a key is
pressed
Press and Hold Key(s) in BLACK
[MODE] [STORE] [+] [-]
[STEP]
[MODE] [STEP] [STORE]
[MODE] [STEP] [STORE] [+]
[MODE] [STEP]
[STORE]
[STEP] [STORE] [+] [-]
[MODE]
DHW Setting: left digit shows
"1" and right digit shows
"140." DO NOT change this
setting. Performance could
be unreliable. Set DHW tank
temp. on DHW aquastat.
After the [stORe] button is pressed, the set value will flash twice to confirm the change. Change will take effect after you leave
(1)
Parameter Mode.
display shows Info until a key is
pressed
Press and Hold Key(s) in BLACK
[MODE] [STORE] [+] [-]
[STEP]
Digits after flashing dot show measured outlet temperature.
(1)
Digits after flashing dot show -18.
(2)
Digits after flashing dot show outside temperature.
(3)
Digits after flashing dot show target outlet temperature.
(4)
Digits after flashing dot show rate of change in °F per second.
(5)
Digits after flashing dot show -32.
(6)
NOte: Display will show A-32 if [steP] is pressed after "9" appears.
Ix - USER INTERFACE qUICK REFERENCE
PARAMETER MODE
Press [MODE] button 1 time from Standby Mode.
Para
then displays Parameter and Current Status.
(1)
Duration
step to next parameter (continue tapping
tap
step to change to 1, 2, 3, or 4)
tap Increase setting
[-]
[+]
Hold FAST increase setting
tap Decrease setting
[-]
Hold FAST Decrease setting
Store current setting (tap this key after setting
[+] [-]
tap
the parameter as desired)
Next mode (info)
tap
DHW Setup: left digit shows "2"
and right digit should show "01."
DO NOT change this setting. DHW
performance could be unreliable or
unsafe.
INFORMATION MODE
Press [MODE] button 2 times from Standby Mode.
Info
then displays Parameter, Flashing Dot, and Current Status.
(1) Duration
step to next
tap
parameter
Result
Space Heating (SH) Setup:
left digit shows "3" and right
digit should show "01." DO
NOT change this setting as it
might affect performance of
your boiler.
Result
Measured outlet water temperature
(First digit shows 1 and dot flashes)
Return water temperature
(First digit shows 2 and dot flashes)
This function not used
(First digit shows 3 and dot flashes)
Outside temperature
(First digit shows 4 and dot flashes)
This function not used
(First digit shows 5 and dot flashes)
Target outlet water temperature
(First digit shows 6 and dot flashes)
Outlet water temp. change over time
(First digit shows 7 and dot flashes)
Return water temp. change over time
(First digit shows 8 and dot flashes)
This function not used
(First digit shows 9 and dot flashes)
21
1 180
1 140
DHW Setting
2
DHW Setup
3
Space Heating Setup
4 190
Outlet Temperature
(see details below)
SH Temperature: left digit shows
"4" and right three digits show
target outlet water temp. (at 32°F
outside if outdoor sensor is used).
adjust to desired settings with +
and - keys.
1.190
1.180
(1)
2.150
(1)
3.-18
(2)
4. 42
(3)
5.-18
(2)
6.190
(4)
7.
(5)
8.
(5)
9.-32
(6)
Display
01
01
Info
Display
1
1