Sony DSR-PD150P Service Manual page 193

2-2-14. L Motor Assembly, Motor Shield, FP-248 Flexible Board, TG1 Spring Hook, Spring Hook Fulcrum Base,
Spring Hook Driving Arm, Worm Shaft, Deceleration Gear and Motor Holder
Removing method
• Refer to the detailed diagram on the right, and remove each part.
TG1 spring hook
Spring hook
fulcrum base
Spring hook
driving arm
Deceleration gear
Attaching method
1. Attach the worm shaft.
1
Insert
Motor holder (Bottom side)
2. Attach the L motor assembly, motor shield and deceleration
gear.
L motor assembly
Positioning hole.
Claw
Claw
2
Motor shield
1
Claw
Motor holder (Top side)
L motor assembly
Motor shield
FP-248 flexible board
(DEW sensor)
Two claws (L motor)
Two claws (motor shield)
Motor holder
Worm shaft
Worm shaft
2
Claw (Insert)
Claw
Motor holder
Deceleration
gear
Positioning boss.
Removal of TG1 spring hook
Rotate to the left slightly opened.
Does not disconnect.
Removal of motor shield and worm shaft
Claw
1
Motor shield
2
Claw
Motor holder
(Top side)
3. Attach the TG1 spring hook to the spring hook fulcrum base.
Rotate to the right slightly opened.
Attach at this position.
4. Attach the spring hook driving arm and spring hook fulcrum
base.
Spring hook
driving arm
5. Grease the part.
Apply the grease
(1.5mm dia.)
5-49
Unhooks.
Disconnects here.
2 Motor shield
Claw
1
Motor holder
(Bottom side)
Hook the hook.
Does not disconnect.
Spring hook
fulcrum base
Claw
Phase
adjustment
L motor block assembly
(Bottom side)