A-2.Cutter Specifications; A-3.Paper Supply Specifications; A-4.Interface Specifications - Oki PT390 User Manual

A-2.
Cutter Specifications
Cutting method: Partial cutting model
Note : For printing on label paper, use only partial cutting. If full cutting is used in
such cases, paper cutting performance will deteriorate faster because of the
greater adverse effect of adhesive matter.
Note : Paper cutting performance may deteriorate faster with the use of label
paper because of its adhesive matter. Clean the cutter blade periodically to
remove the adhesive matter.
Note : Full cutting may lead to irregularities at the center of the cutting surface. If
paper fiber remains at these locations, this may eventually lead to
incomplete cutting at these locations.
Note : In full cutting mode, the printed paper must be removed each time that one
sheet is printed. Otherwise, printed paper remains in the automatic cutter
section and may cause a cutting error.
Note : The maximum number of successive cuts by the cutter is 30 cuts per minute
(at least two seconds per cut). Using the cutter at a higher rate may cause a
failure.

A-3.Paper Supply Specifications

(1) Loading method: Rolls are loaded manually.
(2) Paper near end: Detected when only a little paper is left.
Note:This printer supports paper rolls with a core diameter of φ18mm.

A-4.Interface Specifications

(1) Parallel (Complies with IEEE1284: Nibble mode)
(2) Dual (Conforms to USB 1.1 and RS-232C)
(3) LAN (10BASE-T,100BASE-TX)
The paper remains connected at one point
Partial/full cutting model
A command for switching between partial cutting and
full cutting is provided for models that support these
two cutting methods.
50