Mitsubishi Electric DLP XD460U User Manual page 19

C. Projecting images
Preparation:
• Remove the lens cap.
• Turn on the power of the connected video equipment.
FOCUS ring
ZOOM ring
POWER button
COMPUTER button
1. Confi rm the POWER indicator lights up red.
• If the projector was turned off before the lamp was cooled down suffi ciently last time, the fan may start rotating
and the POWER button may not work after the power cord is plugged. (The STATUS indicator blinks green.)
After the fan stops rotating, press the POWER button to turn back on the POWER indicator.
2. Press the POWER button.
• It may take about one minute for the lamp to light up.
• The lamp fails to light up on rare occasions. In such a case, wait for a few minutes and then try again.
• Do not cover the lens with the lens cap while the lamp is on. Do not strip off the aluminium sheet inside the
lens cap.
• After the POWER button is pressed, the image may fl icker before the lamp becomes stable. This is not a prod-
uct malfunction.
• LAMP MODE can't switch for one minute after the power ON.
• The projector starts warming up when the POWER button is pressed. During the warm-up process, images
may appear dark and no commands are accepted.
• By blinking red, the STATUS indicator indicates that the lamp should be replaced soon. Replace the lamp when
the STATUS indicator blinks red. (See page 33 and 36.)
3. Select an input source.
• Press the VIDEO button on the projector or the VIDEO or S-VIDEO button on the remote control that is
corresponding to the terminal in use.
• The input source is switched between VIDEO and S-VIDEO at every press of the VIDEO button on the projector.
• The VIDEO, S-VIDEO and COMPONENT buttons don't function while the menu is being displayed.
• Though it may take some time before an image is displayed on the screen depending on the type of the input
signal, such symptom is not a malfunction.
• Some images become easier to view when the setting of aspect ratio is changed. (See Page 22.)
• When projecting images from a DVD player that is connected to the DVI connector, press the COMPUTER
button on the projector to select DVI or press the DVI (HDCP) button on the remote control.
• When projecting images from a DVD player that is connected to the COMPUTER 1 or COMPUTER 2 connector,
press the COMPUTER button on the projector to select COMPUTER 1 or 2 or press the COMPUTER 1 or
COMPUTER 2 button on the remote control.
4. Adjust the position of the projector to keep an appropriate projection distance with which images are projected in
their specifi ed sizes.
5. Adjust the position of the projector so that the projector and the screen are perpendicular to each other. (See Page
10.)
• When the projector cannot be positioned perpendicularly to the screen, adjust the projection angle. (See Page
10.)
6. Adjust the size of the projected image by turning the ZOOM ring.
7. Adjust the focus by turning the FOCUS ring.
Repeat steps 4 to 7, if necessary.
DVI-D(HDCP) button
POWER STATUS
AUTO POSITION
COMPUTER KEYSTONE VIDEO
VIDEO button
ENTER
VOLUME
MENU
COMPUTER1, 2 button
POWER button
S-VIDEO button
VIDEO button
EN-19