5-4. Installation Procedures
5-4-1. Installing the TCPs on the Logic Buffer
1) Install the Logic Buffer on the boss holes of the Chassis Base.
2) Stand the connector covers of the Logic Buffer vertically.
3) Connect the TCP film connectors to the Logic Buffer connectors horizontally.
4) Check that the TCP films are securely connected to the Logic Buffer connectors.
5) Place the TCP Cover Plate on the screw holes, and tighten the screws.
6) Tighten the TCP Cover Plate screws in the order of center, and then right and left.
7) Check that the TCP Cover Plate is secured with the screws.
1. Logic Buffer position (E/F/G Buffers)
2. TCP/Logic Buffer assembling
3. Installed TCP
4. TCP Cover Plate assembling
- 34 -