Table of Contents
Advertisement
Operating Instructions
Busch-ComfortTouch
•
White control
Controller 1 = Brightness (display in %)
Controller 2 = Colour temperature
The lamp icon changes according to the setting. This is then also indicated in the control element.
The settings must be confirmed with OK.
3. Preset adjustment
First the lamp must be set as desired. Then the lamp is switched on. This is followed by a long press on the
control element. This saves this lamp setting as a preset. Now the preset is called up at every activation (brief
press). This process must be repeated for each adjustment.
Philips Hue control (only via plug-in)
Philips Hue control elements can be used to define specific settings for Philips Hue lamps. For example, the
colours can be switched or the amount of warm white can be adjusted.
Note
This function is an option and only available with a corresponding plug-in. More detailed
information is available from your electrical installer. He will also carry out the commissioning
process with the aid of the commissioning software.
Control normally takes place using an RGB control element. That is why the explanations for the RGB control
elements in the previous chapters can also be used here.
Note
In contrast to normal KNX actuators, the response of Philips Hue lamps is slightly delayed. They
react generally a little later than the KNX dimming actuator, for example. This is system-dependent
and normal. Since it is a Philips product we have no influence over the matter.
Note
Adjustments to the commissioning of Philips Hue lamps can also be made via the system settings
(see also chapter 5.4.18 "System settings"). The settings can be made under "Philips Hue Bridge
Settings".
Pos: 15.6.48 /Layout bis 2014-11-11/Online-Dokumentation (+KNX)/Steuermodule - Online-Dokumentation (--> Für alle Dokumente <--)/++++++++++++ Seitenumbruch ++++++++++++ @ 9\mod_1268898668093_0.docx @ 52149 @ @ 1
Operating Instructions | 1473-1-8041
®
Operation
— 81 —
Advertisement
Table of Contents
