ABB Busch-ComfortTouch 9 Operating Instructions Manual page 80

Operating Instructions
Busch-ComfortTouch
RGB control
RGB control elements can be used to define specific settings for related bulbs (LEDs, Philips Hue, etc.). For
example, the colours can be switched or the amount of warm white can be adjusted.
The control of a lamp via the RGB control is to be shown by means of an example. Here it should be noted that
the functions which can be called up can vary slightly according to the type of lamp and the default settings in the
commissioning software (which your electrician will appropriately configure). There are lamps without a colour
component, for example. In this case there is only one white control. Which control is possible is indicated in the
control element (in the example: RGB + W, equals colour and white control).
1. Switching the lamp on and off
The lamps are switched on and off by pressing the control element. The icon changes according to the status.
2. White and colour control
The controllers are called up by pressing the arrow. Then the colour or white control can be selected by
pressing one of the two buttons at the top left.
• Colour control
Controller 1 = Brightness (display in %)
Controller 2 = Colour
Controller 3 = Colour saturation
The lamp icon changes according to the setting. This is then also indicated in the control element.
The settings must be confirmed with OK.
Operating Instructions | 1473-1-8041
®
Operation
— 80 —