Table of Contents
Advertisement
Available languages
Available languages
Assembly & Set-Up
Contents of Carton
•
One Tiller
•
One Hardware Pack
WARNING!
To prevent personal injury or property
damage, do not start the engine until all assembly
steps are complete and you have read and understand
the safety and operating instructions.
Recommended Tools for Assembly
•
One 1⁄2" open-ended wrench or socket
•
One 5⁄8" open-ended wrench or socket
•
Scissors (to trim plastic ties)
•
Tire pressure gauge
•
Clean oil funnel
•
Included bottle of oil
Contents of Hardware pack
•
5⁄16-18 Hex Lock Nut (2)
•
5⁄16-18 x .437 x .268 Shoulder Screw (2)
•
.349 x .879 x .063 Flat Washer (2)
•
.450 x 1.000 x .062 Bell Washer (2)
Assembly
Unpacking Instructions
1.
Remove the handle by cutting any straps that secure it to
the carton and set it aside.
2.
Remove any cardboard inserts and packaging material
from the carton. Remove any staples from the bottom of
the carton and remove the carton.
3.
Cut the large, plastic tie straps that secure the tine shield
and weight to the shipping pallet.
4.
The hardware bag is inside the literature envelope. Check
the contents with the list above.
5.
The tiller is heavy. You should not attempt to remove it
from the shipping platform until instructed to do so in
these steps.
•
One Handlebar Assembly
•
One Operator's Manual
Handle
1.
Remove the star knob from the handle. See Figure 3-1.
2.
Using the shoulder screws, hex lock nuts, flat washers (on
the inside of the handle) and bell washers (on the outside
of the handle) from the hardware pack, mount the handle
to the handle mount plate as shown in Figure 3-2.
•
One Bottle Oil
•
One Engine Operator's Manual
Figure 3-1
Figure 3-2
3
7
Advertisement
Chapters
Table of Contents
