Intex Krystal Clear CS15110 Owner's Manual page 34

TROUBLESHOOTING GUIDE (continued)
LED PANEL
CODE
LED Panel Code Flash & Alarm On (NOTE: Always turn off the power before cleaning and servicing).
1. Circulation line is blocked.
2. Incorrect inlet and outlet hose
direction.
3. Scale on the flow sensor.
4. Flow sensor cord is loose.
5. Flow sensor failure.
1. Dirt or scale on titanium plates.
2. Low salt level / No salt.
3. Electrolytic cell cord is loose.
4. Possible electrolytic cell failure.
1. High salt level.
1. Display and all lights are off - the
system does not power up.
SAVE THESE INSTRUCTIONS
(163) MODEL CS15110 SAND FILTER PUMP & FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U
PROBLEM
• If your unit has plunger valves, ensure
•
• Depress the 6-way valve, release all
• Check the direction of the inlet and the
• Clean the flow sensor, paying special
• Plug the flow sensor firmly into the flow
• Contact Intex Service Center.
• Remove the electrolytic cell for
• Add salt. See "Salt & Pool Water
• Ensure that the cell cord is plugged
• Contact Intex Service Center. Replace
• Partially drain the pool and refill it with
• Household voltage is too high or too low
• Contact Intex Service Center.
SOLUTION
that they are open.
Clear your basket and cell from
debris and dirt. See "Maintenance".
trapped air in the circulation line.
outlet hose. Reverse the hoses if
necessary. See "Set Up Instructions".
attention to the hinge. See
"Maintenance".
sensor receptacle.
inspection. Clean it if necessary.
See "Maintenance".
Volumes".
firmly into the cell housing receptacle.
the cell if needed.
fresh water. See "Salt & Pool Water
Volumes".
(+ 20%). Check the voltage is within the
range stated on the device housing.
09/18/2010
English
163
Page 34