Installing The Display Assembly; Removing The Dock Frame - Dell latitude e5270 Owner's Manual

Installing the display assembly

1. Place the display assembly to align with the screw holders on the computer.
2. Tighten the screws to secure the display assembly to the computer.
3. Route the display cable through the routing channel and route the antenna cables by pushing it
through the hole.
4. Connect the antenna cables and display cable to the connectors.
5. Place the display cable bracket over the connector and tighten the screw to secure the display cable
to the computer.
6. Place the display hinge bracket and tighten the screw to secure it to the computer.
7. Install the:
a. WLAN
b. WWAN
c. battery
d. base cover
8. Follow the procedure in

Removing the dock frame

1. Follow the procedure in
2. Remove the:
a. base cover
b. battery
c. hard drive assembly
d. WLAN card
e. WWAN card
3. To remove the dock frame connectors:
a. Remove the screws that secure the dock frame to the computer [1].
b. Remove the screw and lift the SSD plate from the computer [2, 3].
NOTE: Step 3b is required only if the PCIe SSD card is removed.
c. Disconnect the keyboard cables [4, 5].
4. To remove the dock frame:
After working inside your
Before working inside your
or M.2 SSD or PCIe SSD
computer.
computer.
21