Cadillac 2016 Escalade Owner's Manual page 303

302 Vehicle Care
more of the TPMS sensors. The
TPMS sensor matching process
should also be performed after
replacing a spare tyre with a road
tyre containing the TPMS sensor.
The malfunction light and the DIC
message should go off at the next
ignition cycle. The sensors are
matched to the tyre/wheel positions,
using a TPMS relearn tool, in the
following order: driver side front
tyre, passenger side front tyre,
passenger side rear tyre, and driver
side rear tyre. See your dealer for
service or to purchase a
relearn tool.
You have two minutes to match the
first tyre/wheel position, and
five minutes overall to match all four
tyre/wheel positions. If it takes
longer, the matching process stops
and must be restarted.
The TPMS sensor matching process
is outlined below:
1. Apply the parking brake.
2. Place the vehicle power mode
in ON/RUN/START. See
Ignition Positions 0 203.
3. Make sure the Tyre Pressure
info display option is turned on.
The info displays on the DIC
can be turned on and off
through the Settings menu.
See Driver Information Centre
(DIC) 0 142.
4. Use the five-way DIC control
on the right side of the steering
wheel to scroll to the Tyre
Pressure screen under the
DIC info page. See Driver
Information Centre (DIC) 0 142.
5. Press and hold the SEL button
in the centre of the five-way
DIC control.
The horn sounds twice to
signal the receiver is in relearn
mode and the TYRE
LEARNING ACTIVE message
displays on the DIC screen.
6. Start with the driver side
front tyre.
7. Place the relearn tool against
the tyre sidewall, near the
valve stem. Then press the
button to activate the TPMS
sensor. A horn chirp confirms
that the sensor identification
code has been matched to this
tyre and wheel position.
8. Proceed to the passenger side
front tyre, and repeat the
procedure in Step 7.
9. Proceed to the passenger side
rear tyre, and repeat the
procedure in Step 7.
10. Proceed to the driver side rear
tyre, and repeat the procedure
in Step 7. The horn sounds two
times to indicate the sensor
identification code has been
matched to the driver side rear
tyre, and the TPMS sensor
matching process is no longer
active. The TYRE LEARNING
ACTIVE message on the DIC
display screen goes off.
11. Press ENGINE START/STOP
to turn the ignition off.
12. Set all four tyres to the
recommended air pressure
level as indicated on the Tyre
and Loading Information label.