Cadillac 2016 Escalade Owner's Manual page 302

Caution
Tyre sealant materials are not all
the same. A non-approved tyre
sealant could damage the TPMS
sensors. TPMS sensor damage
caused by using an incorrect tyre
sealant is not covered by the
vehicle warranty. Always use only
the GM approved tyre sealant
available through your dealer or
included in the vehicle.
TPMS Malfunction Light and
Message
The TPMS will not function properly
if one or more of the TPMS sensors
are missing or inoperable. When the
system detects a malfunction, the
low tyre warning light flashes for
about one minute and then stays on
for the remainder of the ignition
cycle. A DIC warning message also
displays. The malfunction light and
DIC warning message come on at
each ignition cycle until the problem
is corrected. Some of the conditions
that can cause these to come
on are:
One of the road tyres has been
replaced with the spare tyre. The
spare tyre does not have a
TPMS sensor. The malfunction
light and DIC message should
go off after the road tyre is
replaced and the sensor
matching process is performed
successfully. See TPMS Sensor
Matching Process later in this
section.
The TPMS sensor matching
process was not done or not
completed successfully after
rotating the tyres. The
malfunction light and the DIC
message should go off after
successfully completing the
sensor matching process. See
"TPMS Sensor Matching
Process" later in this section.
One or more TPMS sensors are
missing or damaged. The
malfunction light and the DIC
message should go off when the
TPMS sensors are installed and
Vehicle Care
the sensor matching process is
performed successfully. See
your dealer for service.
Replacement tyres or wheels do
not match the original equipment
tyres or wheels. Tyres and
wheels other than those
recommended could prevent the
TPMS from functioning properly.
See Buying New Tyres 0 305.
Operating electronic devices or
being near facilities using radio
wave frequencies similar to the
TPMS could cause the TPMS
sensors to malfunction.
If the TPMS is not functioning
properly, it cannot detect or signal a
low tyre condition. See your dealer
for service if the TPMS malfunction
light and DIC message come on
and stay on.
TPMS Sensor Matching
Process
Each TPMS sensor has a unique
identification code. The identification
code needs to be matched to a new
tyre/wheel position after rotating the
vehicle's tyres or replacing one or
301