Connecting With A Computer; Using Without Other Scsi Devices - Minolta CD-10 Instruction Manual

4. Connecting with a Computer

D-Sub25 pin
SCSI cable
for Macintosh
computer
50-pin full-pitch
SCSI cable
for IBM PC/AT
compatible
computer
This drive unit connects to a computer through a SCSI ca-
ble. There are two types of connection depending on
whether or not an additional SCSI device is to be used.
These two cases are discussed in this section.
Note: There are several physical forms of SCSI connectors.
Check the SCSI connector of the computer and SCSI device to
be connected and procure a proper SCSI cable.
For connection with an IBM PC/AT compatible computer, a SCSI
board must have been previously mounted in the computer. To
mount a SCSI board, consult the documents included with the
SCSI board.
CAUTION: Turn off the power to the computer and SCSI device(s)
before making the connections.

4-1 Using without other SCSI devices

Plug one end of the SCSI cable into the SCSI connector at
the rear of the computer and the other into the SCSI connec-
tor at the rear of this drive unit. Securely plug the cable end
into the connector then secure it (with clamps or screws
built into the SCSI cable).
SCSI cable
Card Drive CD-10
D-Sub25 pin
SCSI cable for
Macintosh computer
IBM PC/AT compatible computer
11