Interior Strip Lighting; Circuit Breakers - Blue Bird Q - BUS Owner's Manual

INTERIOR STRIP LIGHTING

Your QBRE may be equipped with 12 volt strip lights mounted on the ceiling. The specifications for these
are listed below.
A. DC input voltage (continuous)
B. DC input voltage (peak)
C. DC input current
(with dual F13T5 tubes)
D. RMS output current
E. Operating frequency
(with normal load)
F. Peak output firing voltage
G. Lamp types
H. Starting
I. Transient protection
J. Operating temperature range
K. Protection
L. Length
M. 12V Part No.
N. Tube requirements

CIRCUIT BREAKERS

Body and chassis circuits are protected by
circuit breakers located in a side mounted elec-
trical box below driver's window. If a short
occurs and the circuit breaker breaks, the cir-
cuit will reset itself when the element cools. A
short may be indicated by blinking of lights or
fluctuating gauges. The shorted circuit should
be corrected immediately.
For access to the electrical panel, locate
latch release as shown. Push latch release
downward. This will enable the access door
located on the outside of bus below the driver's
window to open.
8-16 VDC
20 VDC 30 sec.
2.4 A
130ma @ 13.2 VDC input
56 khz
880 V
F4T5 through F13T5
Ballast incorporates a proprietary solid state lamp start-
ing circuit which preaheat-starts lamps and disallows de-
structive cold starting for exceptional lamp life, typically
> 20,000 starts.
Protects ballast from defective tubes or arcing sockets.
-17 deg. C / 0 deg. F to 65 deg. C / 150 deg. F
Over temperature and reverse polarity protected.
48 inches
905-02-006
2-F13T5CW
RELEASE LATCH
14
DRIVER'S SEAT