»
MAINTENANCE WORK ON CHASSIS AND ENGINE
Adjusting the front wheel brake cable (50 Mini Adventure)
The hand brake lever should travel between 10 and 15 mm (0.4-0.6 in) before
the front wheel is actually slowed down.
To adjust the brake control cable, use either the adjusting screw [1] at the
hand brake lever or the adjusting screw [2] at the brake backing plate. Before
1
commencing to adjust the cable, always release the counternut [3]. Afterwards,
4
the counternut must be retightened. Properly remount the rubber protection
piece [4] pulled back earlier.
10-15 mm
After adjusting the cable, always check if the wheel turns smoothly.
3
Checking the front brake linings for wear (50 Mini Adventure)
The brake linings must be replaced when the distance between the hub brake
lever and the cable support, measured with the brake lever squeezed, is less
than 50 mm (2 in) (see illustration).
2
If the brake linings are replaced too late, i.e. when the lining is partly or fully
worn away, the metal shoes will rub against the brake drum, thus reducing
the braking effect and destroying the brake drum.
3
min 50 mm
24