Fisher & Paykel ActiveSmart RF135B Installation Instructions And User Manual page 19

Before you start using your Ice & water refrigerator
Check your refrigerator is switched on.
● ●
Check that the isolation tap has been connected and turned on.
● ●
Run through and discard the first 3 qt (3 liters) of water from your water dispenser,
● ●
stopping intermittently to remove trapped air in the system. Failure to do this will result
in excessive dripping from your dispenser.
Note: there will be a 1 – 2 minute delay while the tank fills until water is dispensed.
Turn the ice maker on by pressing the
● ●
illuminated when the ice maker is on.
Press and hold the
● ●
refrigerator compartment door to force an ice maker cycle. The ice tray will flip twice.
Repeat to force another ice maker cycle. The ice tray will flip twice and spill water into
the ice bin. Empty the water, dry and replace the bin. Note that the ice tray will not flip
until the refrigerator compartment door is closed.
Allow at least 2 hours for your refrigerator to cool before use.
● ●
Please discard the first 3 harvests of ice (8 cubes per harvest).
● ●
You are now ready to enjoy ice and water from your ActiveSmart™ refrigerator.
Please note that once installation is complete a few drips may appear out of the
dispenser over the next few days as the remaining trapped air is cleared.
INSTALLATION INSTRUCTIONS
button. The light above the
, and buttons together for 4 seconds and then close the
Water dispenser
EN
button will be
17