Fisher & Paykel ActiveSmart RF135B Installation Instructions And User Manual page 17

Attach double sided foam to the
!1
back of the water filter head as
shown in Diagram 5. Write the date
to be replaced on the filter (date
installed + 6 months). Remove the
double sided foam backing and
attach the filter to the desired
position, reinforcing the filter with
the screws provided as located in
step 10 (refer to the previous page).
Run the 1/4" (6 mm) tubing to the
!2
back of the refrigerator ensuring
there is enough tubing to pull the
refrigerator out for service.
Using the measurement guide
!3
located on the rear compartment
cover as shown in Diagram 6. Mark
out 5/8" (16 mm), on the end of the
tubing as shown in Diagram 7.
Insert the tubing marked 5/8" (16 mm)
!4
into the water (solenoid) valve up
to the marked line as shown in
Diagram 8.
Pull gently on tubing to ensure it is
!5
locked in as shown in Diagram 9.
The completed installation should
!6
look like Diagram 11 on page 16.
Turn the isolating faucet on and
!7
check that all connections are dry
and free of drips.
Coil water line tubing behind the
!8
refrigerator. Push your refrigerator
into place being careful not to
kink or squash the water line tube
running into the water (solenoid)
valve.
Read pages 16 – 17 carefully and
!9
then turn refrigerator on.
INSTALLATION INSTRUCTIONS
PART: 838587
6
PART: 838587
6
PART: 838587
6 7
7
7
Diagram 6
Diagram 7
Diagram 8
Diagram 9
Waterline connection to refrigerator
EN
DRAWING: 838587
8 9
Diagram 5
Double sided foam
DRAWING: 838587
8
attachment
DRAWING: 838587
8
15
9
9