Adjusting The Pulse Flow Setting - Invacare XPO2 Operator's Manual

Oxygen
Outlet Port
DETAIL
"A"
FIGURE 6.8 Connecting/Positioning the Nasal Cannula

Adjusting the Pulse Flow Setting

It is very important to select the prescribed level of oxygen
flow. DO NOT increase or decrease the flow unless a change
has been prescribed by your physician or therapist.
NOTE: For this procedure, refer to FIGURE 6.9 on page 32.
1. Turn On the XPO
On/Off button for approximately one second. Each time
the XPO is turned On, a brief alarm will sound. The XPO
2
pulse flow setting at power-up will be the same flow
setting selected the last time the unit was turned Off.
2. The XPO
2
selection (+ or -) button until your prescribed flow setting
(1 to 5) is illuminated by a blue indicator light.
FLOW SETTING
1
Part No 1160887
SECTION 6—OPERATING INSTRUCTIONS
Nasal
Cannula
CAUTION
by pressing and holding the power
2
has five pulse flow settings. Press the flow
AVERAGE PULSE VOLUME (AT 20
DETAIL "B"
BREATHS PER MINUTE)
15 ml
31 Invacare® XPO ™
2
2