More Information; Troubleshooting - Rotel RSX-03 Owner's Manual

RSX-03 Surround Sound Receiver
To change the PASSWORD: Place the
highlight on the SET NEW PASSWORD line
using the UP/DOWN buttons and use the
+/– buttons to change the setting to YES.
Press the ENTER button. The SET NEW PASS-
WORD screen appears.
������������������������
�����������
������������������������
�������
������������������������
������
������������������������
�����
�����
����������������������
1. Enter the old 4-digit password on the first
line. If you are changing the password
for the first time, enter the initial factory
password "0000" here.
2. Enter the new 4-digit password of your
choice on the second line.
3. Re-enter the new password on the third
line to confirm.
4. To return to the DEFAULT SETUP menu
without saving any changes, use the
UP/DOWN buttons to highlight DEFAULT
SETUP MENU and press ENTER.
: If you forget your password, you can
NOTE
enter the universal password "8888" as the
old password, thus allowing you to choose
a new password.

MORE INFORMATION

Troubleshooting

The unit does not turn on.
• Make sure the power cord is plugged
into the rear panel and a live AC wall
outlet.
• Make sure the rear panel POWER switch
is in the ON position.
No sound from any input.
• Make sure that MUTING is off and VOL-
UME is turned up.
• Make sure that speakers are wired cor-
rectly.
• Make sure source inputs are connected
and configured correctly.
No sound from digital sources.
• Make sure that digital input connector is
assigned to the proper source input and
that the source input is configured to use
the digital input rather than an analog
input.
• Check the configuration of the DVD player
to ensure that the bitstream and/or DTS
digital output is activated.
No sound from some speakers.
• Check all power amp and speaker con-
nections.
• Check Speaker Configuration settings in
the Setup menus.
No video output on TV monitor.
• Make sure that the TV monitor is connected
properly. Component video outputs can
only send video from Component video
sources to the TV. Composite video connec-
tions can only send video from composite
sources and S-Video connections can only
send video from S-Video sources.
• Make sure the NTSC/PAL switch is set
properly.
40
OSD menus are not displayed on TV
Monitor.
• Go to Setup menus and configure OSD
menus to be displayed on the TV moni-
tor.
• In some PAL systems, the menus may not
be displayed unless there is an active
video signal.
• When using progressive scan video
signals, make sure that the progressive
mode is selected for that video input in the
OTHER OPTIONS setup menu. This allows
the display of the main setup OSD menus
on the TV monitor by interrupting the pro-
gressive scan video signal and restoring it
after the OSD menus are cancelled. The
temporary information screens (such as
volume, etc.) cannot be displayed on the
TV monitor when progressive scan signals
are being used.
Video and Audio do not match.
• Check that the proper video source is se-
lected for each input.
Clicking or popping sounds when
switching inputs.
• The unit uses relay switching to preserve
maximum sound quality. The mechanical
clicking of the relays is normal.
• During switching, it may take a split sec-
ond for digital signals to be recognized
and properly decoded. Rapid repeated
switching between inputs or settings can
result in clicks or pops from the speak-
ers as the unit attempts to lock on to the
rapidly changing signals. This causes no
harm.
Controls do not operate.
• Make sure that fresh batteries are installed
in the remote.
• Make sure that the IR sensor on the front
panel is not blocked. Aim the remote at
the sensor.
• Make sure the sensor is not receiving strong
IR light (sunlight, halogen lighting, etc.)
• Unplug the unit from the AC outlet, wait 30
seconds, and plug it back in to reset.