Volt-Ampere Curves; Installing Turntable For Wire Feeder On Power Source (Optional) - Miller Electric XMS 4000 Owner's Manual

3-3. Volt-Ampere Curves

3-4. Installing Turntable for Wire Feeder on Power Source (Optional)

OM-224 043 Page 10
A. CC Mode
ARC CONTROL
1
2
Volt-ampere curves show minimum
and maximum voltage and amper-
age output capabilities of unit.
Curves of other settings fall be-
tween curves shown.
B. CV Mode
va_curve1 4/95 − SA-178 652 / SA-178 653
Y Turn off welding power
source and disconnect input
power before proceeding.
Remove wire spool.
1 Turntable
2 Screw
Remove the 4 screws and the plas-
tic cap on the power source upper
cover and keep them for future use.
Insert the turntable in the upper hole
and secure with 4 screws. Be sure
screws are tight.
If desired, install the wire feeder on
the turntable using the hole in the
bottom of the feeder.