Resetting The Unit; Care And Maintenance - LENCO SR-600 BT User Manual

cable into the device you wish to charge.
3. Observe the battery charge indicator on your device to make sure the charging
process starts normally.
4. Unplug the cable when your device is fully charged.
CAUTION:
Before charging, please refer to the user manual of the device you wish to charge to
make sure the charging current requested does not exceed 1A (1000mA). Overloading
the charging circuit may damage the SR-600 BT permanently and void the warranty.
1. The USB charging port (#16) of the SR-600 BT supplies a DC 5V output at
1000mA maximum current to charge your smart phone or portable device battery
and it cannot support any other voltage range.
2. Make sure the device you want to charge has a battery charge rating of DC 5V
only.
3. The USB port of the SR-600 BT is designed for smart phone or portable device
battery charging only and it cannot support data transfer or connect to computer.
4. Do not connect the USB port of the SR-600 BT to other external power charger
USB ports, it may damage both units and void the warranty.
Note:
1. Some smart phones and portable devices use proprietary USB connections and
circuitry, so they may not charge when plugged into the USB port. Please refer to
your device user manual before you attempt to charge them.
2. It is normal if the unit gets warm while the USB CHARGING PORT (#16) is in use
and charging your smart phone or portable device.
3. Do not charge your smart phone over 12 hours continuously. Disconnect your
smart phone or other portable device from the USB cord once it is fully charged.
SYSTEM RESET
If the unit experiences a power surge or electric shock, it is possible that the internal
micro-controller may lock and the unit will not respond to any commands from the
panel control. In this event, Disconnect the AC power and remove all inserted batteries
and button cells for around one minute. Reinsert the batteries and reconnect the power
once the time has passed.
1. Avoid operating your unit under direct sunlight or in hot, humid or dusty places.
2. Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors.
3. Unplug the unit from the electrical power outlet immediately in case of malfunction.

RESETTING THE UNIT

CARE AND MAINTENANCE

E-10