4 Use your TV
Switching on your TV and putting it in
Standby mode
TV
Remote Control
To Turn the TV On from Standby or Off to Standby
•
Press B on the Side panel or the Remote Control.
Note(s)
•
Energy Consumption contributes to air and water pollution. When the AC Power Cord is plugged
in, your TV consumes energy with a very low Standby Power Consumption.
Adjusting Volume
TV
Remote Control
To decrease or increase Volume
•
Press VOL J / K on the Side panel or press VOL + / – on the Remote
Control.
VOL J (–) : Volume Down
VOL K (+) : Volume Up
To mute or unmute sound
•
Press V on the Remote Control to mute the sound.
•
Press V again or VOL + / – to recover the original sound.
Switching Channels
TV
Remote Control
To Select Channels by using CH H / I or CH + / –
•
Press CH H (Up) / I (Down) on the side panel or press CH + / – on the
Remote Control.
To Select Channels by using the NUMBER buttons
Digital TV Operation
•
For Digital channels, press a number followed by a dot "•" and the
corresponding sub channel number.
–When selecting Digital channel 1 1. 1
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV Operation
–When selecting Cable or Analog channel 1 1
Press PREV.CH to return to the previously viewed channel.
Note(s)
•
To Select the non-memorized channels, use the NUMBER buttons.
•
Channel not available or No signal will appear on the TV screen after the subchannel broadcast
is over.
•
Audio only message will appear on the TV screen, when you receive only sound signal.
19
.
English
Continued on next page.