Windows Nt 4.0; Method 1: Display Property Page - Asus V9520 Home Theater User Manual

Asustek computer multimedia remote control user manual v9520

Hide thumbs Also See for V9520 Home Theater:

Table of Contents

4.1.4

Windows NT 4.0

Before installing the display driver in Windows NT 4.0, make sure that

you have installed Windows NT 4.0 Service Pack 3 or later to take

full advantage of the AGP features of your card.

The following steps assume your CD-ROM drive letter is D.

1. Boot Windows NT system and log on as Administrator.

2. Switch display properties to VGA mode (16 colors, 640 x 480 pixels),

then restart your computer.

3. After startup, right-click the Windows NT desktop and click Properties.

4. Select the Settings tab.

5. Select Change Display Type.

6. Select Adapter Type and click Change.

7. Click Have Disk.

8. Insert the support CD.

9. Type D:\NT40 or click Browse to select the path of the display driver for

Windows NT then click OK.

10. Select your ASUS VGA Card model then click OK.

11. Windows NT will once again prompt for confirmation. Confirm installation

of display drivers to copy all appropriate files. When all files are copied,

click Close go back to the Display Properties box then click Apply.

12. The System Settings Change dialog box is displayed. Click Yes to reboot

computer.

13. Windows NT will restart with the default settings. The Display applet will

appear to allow for mode selection.

ASUS V9520 Home Theater User Guide

Table of Contents