Continuous Shooting (Burst Mode) - FujiFilm X-E2S Owner's Manual

Continuous Shooting (Burst Mode)

Continuous Shooting (Burst Mode)
Capture motion in a series of pictures.
1
Press the DRIVE button to display drive options.
2 Press the selector up or down to highlight I,
then press the selector left or right to choose
a frame rate of J (high) or O (low). Press
MENU/OK to proceed when settings are com-
plete.
3 Press the shutter button halfway to focus.
4
Press the shutter button the rest of the way
down to start shooting. Shooting ends when
the shutter button is released, the maximum
number of pictures has been taken, or the
memory card is full.
R Frame rate varies with the subject, shutter speed,
sensitivity, and focus mode and may slow as more
shots are taken.
R The fl ash turns off automatically; the previously-se-
lected fl ash mode is restored when burst shooting
is disabled.
R Additional time may be required to record pictures
when shooting ends.
R If fi le numbering reaches 999 before shooting is
complete, the remaining pictures will be recorded
to a new folder (P 110).
R In some drive modes, shooting may not begin if the
space available on the memory card is insuffi cient.
Focus and Exposure Focus and Exposure
To vary focus and exposure with each shot, select fo-
cus mode C; in other modes, focus and exposure are
determined by the fi rst shot in each series.
Q Selecting J in focus mode C restricts the choice of focus
frames (P 74).
Q Exposure and focus tracking performance may vary with
aperture, sensitivity, and shooting conditions.
The DRIVE Button
61