Panasonic SC-ALL70T Operating Instructions Manual page 22

Method 3:
Using a LAN cable
e.g., LAN cable (not supplied)
Broadband router,
etc.
1 Disconnect the AC mains lead.
2 Connect the main unit to a
broadband router, etc. using a LAN
cable.
3 Connect the AC mains lead to the
main unit and turn this system on.
≥ When the connection is established, "
indicated on the main unit's display.
≥ Use category 5 or above straight LAN cables (STP)
when connecting to peripheral devices.
≥ The LAN cable must be connected or disconnected while
the AC mains lead is disconnected.
≥ Inserting any cable other than a LAN cable in the LAN
port can damage the system.
≥ If the LAN cable is disconnected, the network-related
settings ( right) will be initialized. In that case, make
the settings again.
≥ When a LAN cable is connected, the Wi-Fi function will
be disabled.
22
SQT0935
∫ To make network-related settings
You can change this system's name on the
network, and use specific IP address, subnet
mask, default gateway, primary DNS, etc.
You can also change the name of this system
by changing a setting in the app "Panasonic
Music Streaming" (
app, refer to the site below.
≥ Always use the latest version of the app.
http://panasonic.jp/support/global/cs/audio/app/
(This site is in English only.)
Preparation
≥ Connect this system to the network with a
cable. (
≥ Connect your device to the same network as
this system.
≥ Check this system's IP address (
"NET INFO"), and note it down.
1 Start an Internet browser on your
device and then type this system's IP
" is
address into the address field to
display the settings page.
≥ It may take a few minutes until the settings page is
2 Type a device name and then select
"Next".
≥ Refer to the step 6 of "Using an Internet browser"
3 Select and input the details.
≥ If your network requires specific settings, deselect
4 Select "Connect" to apply the settings.
≥ When the connection is established, "
24). For details on the
left)
displayed depending on the environment. In that
case, reload the browser.
( 20) for details on a device name.
"DHCP" to disable DHCP.
– You can use specific IP address, subnet mask,
default gateway, primary DNS, etc.
indicated on the main unit's display.
31,
" is