Hotpoint CSM22GRD WW Owner's Manual page 16

About the ice and water dispenser.
16
Ice Storage Bin
To remove: Lift the left corner to free the
bin from the shelf and pull the bin
straight out while supporting it at front
and rear.
To replace: Slide the bin back until the
tab on the bin locks into the slot on the
shelf. If the bin does not go all the way
back, remove it and rotate the drive
mechanism 1/4 turn. Then push the bin
back again until the tab on the bin locks
into the slot on the shelf.
Important Facts About Your Dispenser
Add ice before filling the glass with a
beverage.
Do not add ice from trays or bags to
the storage bin. It may not crush or
dispense well.
Avoid overfilling glass with ice and use
of narrow or extra-tall glasses. Backed-
up ice can jam the chute or cause the
door in the chute to freeze shut. If ice
is blocking the chute, poke it through
with a wooden spoon.
Beverages and foods should not be
quick-chilled in the ice storage bin.
Cans, bottles or food packages in the
storage bin may cause the icemaker
or auger to jam.
(On some models)
Rotate
Drive
Mechanism
Some crushed ice may be dispensed
even though you selected CUBED ICE.
This happens occasionally when a few
cubes accidentally get directed to the
crusher.
After crushed ice is dispensed, some
water may drip from the chute.
Sometimes a mound of snow will form
on the door in the ice chute. This
condition is normal and usually occurs
when you have dispensed crushed ice
repeatedly. The snow will eventually
evaporate.
Dispensed water is not ice cold. For
colder water, add crushed ice or cubes
before dispensing water.