Canon VB-R11VE Operation Manual page 70

[Use DHCP]
The camera time is synchronized with the time of the NTP server at the address acquired from the DHCP server. The
acquired NTP server address appears in [NTP Server (DHCP)].
In order to set [Use DHCP], you must change [Network] > [IPv4] > [IPv4 Address Setting Method] to [Auto (DHCP)]
(P. 64).
[Use DHCPv6]
The camera time is synchronized with the time of the NTP server at the address acquired from the DHCPv6 server.
The acquired NTP server address appears in [NTP Server (DHCPv6)].
In order to set [Use DHCPv6], you must change [Network] > [IPv6] > [Use IPv6] to [Enable], then set [Auto
(DHCPv6)] to [Enable] (P. 65).
[Use DHCP/DHCPv6]
The camera time is synchronized with the time of the NTP server at the address acquired from the DHCP server or
DHCPv6 server.
If the NTP server (address) can be acquired from both the DHCP server (IPv4) and DHCPv6 server, the NTP server
address acquired from the DHCP server (IPv4) will be used.
[Synchronize with NTP broadcast]
The camera will synchronize time with NTP broadcasts received from the NTP server.
The camera's NTP broadcast mode does not support IPv6.
[Synchronize with computer time]
The date and time will be synchronized with that of the computer currently accessing the camera. After clicking [Apply],
[Setting Method] will change to [Set manually].
[Time Zone] is not automatically selected, so set it if necessary.
Note
• If the NTP server IP address is incorrect or a connection with the NTP server cannot otherwise be established, the date and time will not
be changed.
70