Emergency Lowering - Superior M User Manual

Standing position with electrical raising
Preparations before standing position
Never stand alone the first time you test your wheelchair. Raising may affect your
bloodpreasure and cause fainting etc.
The chair must be in the brake mode before raising.
At the uprising with the
at a safe distance from slopes, ravines, stairs, etc. Make sure that the front support
legs end up on the flat surface when standing up.
Assemble the shank support on the extendable arms that are places on the right and
left side in front of the brake levers. Make sure that the support is properly assembled
before raising.
A belt must be used at all raising.
If the belt is equipped with a "snap"—locking buckle, press it together until you
here a clicking sound. Pull the belt just tight enough for the users chestsize. To
open, push the buttom in the middle of the buckle and pull apart.
What position and what type of belt to use shall be decided at the testing,
depending on the users need, in cooperation with authorized staff.
If the wheelchair is equipped with "banana" armrests, they must be folded up in
front of the user.
När alla säkerhets anordningar är fastsatta så sköts uppresningen genom en
knapptryckning på manöverdosan.
Manöverdosan är märkt med upp och ned pilar för val av upp och nedfärd.

Emergency lowering

If the wheelchair should get stuck in a standing position, the chair needs to be
emergency lowered. This can be done in two ways;
1) If the wheelchair should get stuck in a standing position due to a low battery,
just connect the battery charger to the control box and in the nearest socket.
The chair is low lowered by direct elictricity. The chair shall be left on charge at
least 12 hours if the battery was empty.
Superior
, all four wheels must remain on solid level ground
Radiovägen 3, 135 48 Tyresö
08-776 26 54
www.superiorstanding.com
e.mail : info@superiorstanding.com
Artnr: S333001
Version: 1.1