On-Screen Manager (Osm ) - NEC MultiSync E900+ User Manual

On-Screen Manager (OSM )

To attach the MultiSync E900+ monitor to your system, follow these
instructions:
1. Turn off the power to your computer and MultiSync monitor.
2. If necessary, install the display card. For more information, refer to
the display card manual.
3. For the PC: Connect the MultiSync E900+ monitor's video cable
to the display card's connector on the computer. Tighten screws on
all connectors.
For the Mac: Connect the MultiSync Macintosh Cable Adapter to
the monitor's connector on your computer. Connect the MultiSync
E900+ monitor's signal cable to the other end of the cable adapter.
Tighten screws on all connectors.
4. Connect one end of the power cable to the MultiSync E900+
monitor and the other end to the power outlet.
5. Turn on your MultiSync monitor and computer.
6. This completes the installation.
NOTE: If you have any problems, please refer to the
Troubleshooting section of this manual.
On-Screen Manager (OSM )
Now, On-Screen Manager (OSM ) Controls have made the MultiSync
monitor's Advanced Digital Control System easier to use by providing
menus on screen. A touch of the up front controls turns on OSM, allowing
you to easily navigate through menus and adjust controls.
OSM allows you to control Brightness, Contrast, Size, Position, Geometry
and other OSM Utilities. User adjustments are saved automatically when
you change menus. Controls can be reset to factory settings by pressing the
reset button.
E - 9