Setting The System Date And Time - DSC Power632 PC1555 Instruction Manual

To view troubles from an LED or Fixed Message LCD5501Z keypad:
A trouble will be indicated by the Trouble light/message, which will remain ON until the trouble condition
is cleared. If you cannot determine the cause of the trouble condition, contact your installer for assistance.
To view the type of trouble condition, press [*][2]. One or more zone indicators will turn ON, indicating
the various trouble conditions:
ZONE iNDICATOR TYPE OF TROUBLE
1 ................. Service required. Call your installation company for service.
2 ................. Indicates the loss of AC power. When this trouble occurs, the Trouble light will turn
ON but keypad buzzer will not sound.
3 ................. Telephone line trouble.
4 ................. The panel has failed to communicate with the central station.
5 ................. Zone fault. Press [5], the zone indicator(s) corresponding to the faulted zones will turn ON.
6 ................. Zone tamper. Press [6] and the zone indicator(s) corresponding to the tampered
zones will turn ON.
7 ................. Low zone battery. This trouble is generated when a wireless device exhibits a low
battery condition.
Press [7] one, two, or three times to view which devices are experiencing battery
failure. The following will occur:
Keypad beeps: Keypad displays:
Press [7] 1 Zones with low batteries (LED/Fixed Message LCD keypad -
zone indicators 1 to 32)
Press [7] again 2 Handheld keypads with low batteries (LED/Fixed Message
LCD keypad - zone indicators 1 to 4)
Press [7] again 3 Wireless keys with low batteries (LED keypad - zone
indicators 1 to 8). To view the battery conditions of wireless
keys 9 through 16, you must be at an LCD keypad.
...... ... Loss of time on system clock. To set the system time, follow the instructions in
"Setting System Date and Time" on page 12.
To view troubles from an LCD Keypad:
From the Ready state, use the arrow (< >) keys to scroll to the following message.
Sustern TrOuble Press [*][2] key to view the trouble. The message will read...
(*2) t.c, I.,Iirlil
^.:^iei.o Tr,ub1e ::• Use the arrow (< >) keys to view which troubles are present on the system. Once you
Troublp Me_=.dae" have scrolled through the list of troubles, press the [#] key to exit the Trouble Viewing
mode and return to the Ready state.
Setting the System Date and Time
To set the system time, enter [*][6] followed by the Master Code. Press [1]. The keypad will now accept
10 consecutive digits:
• Enter the Time in Hours and Minutes using the 24-hr format (00:00 to 23:59).
• Enter the Date in Months, Days and Years (MM DD YY).
NOTE: If you have an LCD keypad, your installer may have programmed your system to display the time
and date while the keypad is idle. If this is the case, you may have to press the [#] key to clear the
date and time before entering an access code to arm the system, or before performing any other
keypad function.
12