Advertisement
ENT OF COMMUNICATIONS
NOTICE
The Canadian Department of
Communications label identifies certified
equipment. This certification means that
the equipment meets certain telecom-
munications network protective,
opemtional and safety requirements The
Department does not guarantee the
equipment will operate to the user's
satisfaction.
Before installing this equipment, users
should ensure that it is permissible to be
connected to the facilities of the local
equipment must also be installed using an
approved method of connection. The
method of connection approved for this
equipment as designated by D.O.C.
Standard CS-03 is a CAllA or CAllW
connection arrangement. The A or W
suffix indicates that either desk or wall
mounting is approved. In some cases, the
company's inside wiring associated with
a single line individual service may be
extended by means of a certified jack-
ensemble (telephone
plug-cord
extension cord). The customer should be
aware that compliance with the above
conditions may not prevent degradation
of service in some situations
10
Existing telecommunications company
requirements do not permit their
equipment to be connected to customer-
provided
except where specified by
jacks
individual telecommunications company
tariffs
Repairs
certified equipment should be
to
made by an authorized Canadian
maintenance facility designated by the
supplier. Any repairs or alterations made
by the user to this equipment. or
equipment malfunctions, may give the
telecommunications company cause to
request the user to disconnect the
equipment.
Users should ensure for their own
protection that the electrical ground
connections of the power utility,
telephone lines and internal metallic
water pipe system, if present. are
connected together. This precaution may
be particularly important in rural areas.
Users should not attempt to
Caution:
make such connections themselves, but
should contact the appropriate electric
inspection authority, or electrician, as
appropriate.
LOAD NUMBER
The load number of the telephone is 10A.
Load numbers are a new concept
deslgned to help you determine how
many telephones can be connected to
any one telephone line. The total of the
load numbers for all the telephones
connected to any one line should not
exceed 100. An alphabetic suffix Is also
specified to indicate the appropriate
ringer type (A or B).
Since the load numbers are new,you may
not know what the load numbers are for
your previous telephones It is usually safe
to assume that the load numbers for them
will be about 20. This means that there
should be no problems with up to five
telephones on one line.
If the maximum total load number of 100
is exceeded, the telephone on that line
may not ring or may ring poorly. In
addition, you may not be connected to
the calling party when you pick up the
receiver or you may have dialing
problems
If you experience the above problems
after the addition of a telephone to your
line. you may have exceeded the
maximum load number of 100. In this
case, you will have to disconnect ohq of
the telephones to reduce your total
number below 100.
1
1
Advertisement
